Wind Direction device High quality, High Accuracy Professionnal...
Electric Push Rod Push length: 100mm Volt: 6V Force: 128 N
IDC 2x20 Female connector TO FPC 40 pins ribbon at 0.5mm spacing
Connecteur IDC Male 2x20 pins FPC 40 lines connector @ 0.5mm
NE555 timer 100 KHz Max 4.5 ~ 16V 10mA DIP 8
NTC / CTN Thermistor -55°C à 300°C 10 KOhms GT103J1K
6V Air Valve 2 Pins JST PH connector 1 common port 2 ways FA0520E
Weight / Force sensor 0 to 1 Kg HX711 amplifier - amplifier for load...
Robotic + microcontroler board 32u4 - Arduino Leonardo compatible Motor:...
Servo Hat for Stick C / Stick C plus Servo driver (STM32F0) 4 Servos...
The Raspberry Pi B+ and A+ is a nano computer designed to fit on a single board (created by the Raspberry Pi foundation in UK). The aim of the foundation is to stimulate the STEM learning at school. The Pi does not includes hard-drive or SDD disk so the board relies on a SD card to store the operating system and offering long term storage. Raspberry Pi® and its logo are a trademark from the Raspberry-Pi foundation. More information on raspberrypi.org or wikipedia ( fr.wikipedia.org/wiki/Raspberry_Pi ).
A HUB 3x USB +1x Convenient Ethernet for Raspberry-Pi
Infrared Camera Module for Raspberry Pi - 8 MegaPixels
3.5" TFT display for Raspberry Pi 3.5" diagonal 480x320 Interface GPIO (SPI) Touch (via SPI)
7" TFT moniteur with High resolution display for embeded project 7" Diagonal 1280x800 (720p) IPS HDMI/VGA/PAL/NTSC 9V power supply
MaKey MaKey - A revolutionary interface for PC/MAC/Linux... and therefore also a Raspberry
HDMI to VGA converter to connect your Pi to an old VGA monitor
USB serial console / debug cable, Logic 3.3V, for Raspberry Pi and BeagleBone Black
USB adapter for reading and writing Micro SD, Micro SDHC, Micro SDXC cards.
Convert an HDMI plug to DVI-D. Ideal for connecting a Raspberry-Pi to a monitor.
A miniature WiFi module for Raspberry-Pi and PLUS. 802.11b/g/n standard
USB WiFi module (802.11b/g/n) with antenna
USB cable A/microB, 2 meters, power cable
USB Cable A/microB, 1 meter
Afficheur pour Raspberry Pi RGB display 2x16 characters Positive display (back in RGB, Letter in black) keypad 5 buttons!
2 relay (Single Pole, Double throw) 4 momentaneous switch 8 digital input 8 output (open-collector) 8 LEDs (indicator) Python 2 and 3, Scratch and C Emulator and graphical simulator
Ethernet network cable of 3m with its 8 wires present and connected.
Logic converter 4-channels (4 bits) 3.3V 5V, bi-directional, compatible for bus I2C
5V <-> 3V to 8-channel bidirectional Logic converter
Pin-Stacking header 26 pins for GPIO of Pi B and Pi B+
Assortment of BreadBoard wires Female-Female 300mm and 75 mm + Long PinHeader
1 Meter HDMI cable