25 Max. per order Raspberry-Pi Pico Microcontoler RP2040 Cortex M0+ @...
The Raspberry Pi 3 - even faster than the Pi 2, 1 Giga of RAM, WiFi...
Assortment of BreadBoard wires Female-Female 300mm and 75 mm + Long...
MAX PURCHASE 1 or 2 per person during global component back-out period...
MAX PURCHASE 1 or 2 per person during global component back-out period...
Manufacturers
Desolder/Solder Gel Flux - 10 gr Smooth Flow Tack Flux NO CLEAN Hot Air...
Gravity : Measurement of pH of a solution 0 to 14 pH (+/- 0.1 pH) Gain...
Soldering Flux - Gel - 10 gr High quality, High fluidity NO CLEAN Hot...
Motors control board for Raspberry-Pi Pico 4 DC motor 2 stepper motor 8...
MD2 drone Kit to assemble (Learning and Makers) Repairable Payload:...
Air:bit - Drone for Micro:bit Real time measures Code Bloc programmable...
Backplane prototyping board DIN case: 6 modules Level: Backplane...
Viewed products
Nut holder & foot M2.5 H: 5mm D:...
VIS-PIEGE-ECROU-4
Nut holder & foot
In stock
Availability date:
Derived from the VentilaPi4 project (used to cool down the Raspberry-Pi 4), this is a set of 4 nut-trap designed for M2.5 screw and spacers as used with the Ventilla Pi 4
Those nut trap are made with a room underside the piece, a room where you fit the M2.5 nut before you screw it on the spacer (or a screw).
In the VentillaPi4 project, those pieces are used to lever Raspberry-Pi 4 of the desk (when not using it with an official case). That would avoids thermal heat to accumulates under the board.
Thoses pieces are made with 3D printing material, screws and nut not included.