UEXT Lora module (868 MHz, EU) with Duck antenna
868 Mhz is the LoRa frequency for Europe. This module expose a uFL connector to connect the PCB antenna (offering 3 dBi of gain). The Duck Antena includes a 30cm cable.
This UEXT module is easy to connect on board exposing UEXT connector. You can also connect the module with Dupond wires.
The SX1276 module uses all the lines available on the UEXT SPI (main interface), UART and I2C. Uart and I2C bus on the UEXT are also required.
What's UEXT ?
UEXT is a connector carrying I2C bus + SPI bus + Serial + 3.3v power. It use a very standard 10 Pin IDC connector. It is quite easy to add sensors and extension board with UEXT connector... just plug it or wire it with IDC ribbon! Great.
Our favorite is the carrying of I2C bus allowing to easily add several sensors and expansion board. On the other side, SPI would be welcome for fast data transmission like remote screen. The serial connexion could be made compatible with RS-232, RS-422, RS-485, DMX512, MIDI by using appropriate level-shifting circuitery.
This connector is usually available on almost Olimex's product including nano computers. It is a great way to add extension boards on products like ESP8266 WiFi microcontroler or microcontroler board. UEXT is suited for prototyping, school learning (no need for iron) and industrial solution (Olimex produces Industrial Grade boards).
See our UEXT expansion or all products exposing UEXT connector on the shop, the Olimex's UEXT collection, Wikipedia to learn more about UEXT.
- SX1276 transciever
- SPI interface up to 10Mhz SCK
- All UEXT signals are used.
- ALL UEXT signals used!
- Voltage: 1.8 to 3.7V DC (3.3V)
- External antenna u.FL connector
- Temperature: -40 to +85C
- Size: 22.86 x 26 mm
- Schematic (pdf)
- Supplier product sheet
Evaluation Board/Kit Important Notice
Adafruit Industries Ltd provides the enclosed product(s) under the following conditions:
This evaluation board/kit/module is intended for use for ENGINEERING DEVELOPMENT, DEMONSTRATION OR EVALUATION PURPOSES ONLY and is not considered by Adafruit Industries Ltd to be finished end-product fit for general consumer use. Persons handling the product must have electronics training and observe good engineering practice standards. As such the goods being provided are not intended to be complete in terms of required design-, marketing-, and/or manufacturing related protective considerations, including product safety and environmental measures typically found in the products that incorporate such semiconductor components or circuit boards. This evaluation board/kit/module does not fall within the scope of the European Union directives regarding electromagnetic compatibility, FCC, CE or UL and therefore may not meet the technical requirements of these directives or other related documents.
Creating a prototype with this evaluation board/kit/module must repect the applicable law in the country, including radio frequency regulations. Creating a product with this evaluation board/kit/module must also follows the applicable laws and regulations, the final assembly MUST BE CERTIFIED be certified accordingly to European RED directive and/or its translation in the local law.
The user assumes all responsibility and liability for proper and safe handling of the goods. Further the user indemnifies Adafruit Industries Ltd and MC Hobby SPRL from all claims arising from the handling or use of the goods. Due to the open construction of the product, it's the user responsibility to take any and all appropriate precautions with regard to electrostatic discharge, conducted and radiated emissions.
EXCEPT TO THE EXTENT OF THE INDEMNITY SET FORTH ABOVE NEITHER PARTY SHALL BE LIABLE TO THE OTHER FOR ANY INDIRECT SPECIAL INCIDENTAL OR CONSEQUENTIAL DAMAGES.