SSD 128Go - M.2 NVMe 2242 B+M - for Raspberry-Pi

A 128 Go SSD M.2 disk for Raspberry-Pi preloaded with Raspberry-Pi OS

Once connected to the M.2 Hat, you will be surprised by the performances of this new storage device for Raspberry-Pi. the operating system is loaded instantaneously!

Shipped preloaded with Raspberry-Pi OS 64 bits (Desktop edition + recommended software) you will be able to start the Operating System setup at first power-up. You will not have to install the OS on the SSD, it is already there.

Just remove the SD Card and power-up your Pi!

This product requires an adapter to work with the Raspberry-Pi:

• for Raspberry-Pi 5: a M2 PCIe HAT for Raspberry-Pi 5 to connect on the new RPI PCIe bus.
• for Raspberry-Pi 4: an USB --vers--> M.2 Hat adapter
• for Compute Module 4: a carrier board with M.2 interface

Warning:

• This product is a consumable with a pre-installed operating system. It is neither returned nor exchanged!!
• Will requires the latest Boot EEPROM on the Pi 5 (see tutorial section)
• Do not format this disque if you want to use it with a Raspberry-Pi.

Technical details

• PCIe Gen 3 x 2
  Can be used with NVidia Jetson, Windows, Linux
• PCI Express Base 3.1
• NVMe 1.3
• SMART & TRIM
• Advanced Flash Management
• Read up to 1700 MB/s
• Write up to 600 MB/s
• Temp: 0 to 70°C

Content

For each order, you will receive:

• The SSD NVMe disk of 128Go
• Preloaded with Raspberry-Pi OS Bookwork 64 bits