WiPy - MicroPython WiFi...
25 Max. per order Raspberry-Pi Pico Microcontoler RP2040 Cortex M0+ @...
The Raspberry Pi 3 - even faster than the Pi 2, 1 Giga of RAM, WiFi...
Assortment of BreadBoard wires Female-Female 300mm and 75 mm + Long...
MAX PURCHASE 1 or 2 per person during global component back-out period...
MAX PURCHASE 1 or 2 per person during global component back-out period...
Manufacturers
Desolder/Solder Gel Flux - 10 gr Smooth Flow Tack Flux NO CLEAN Hot Air...
Gravity : Measurement of pH of a solution 0 to 14 pH (+/- 0.1 pH) Gain...
Soldering Flux - Gel - 10 gr High quality, High fluidity NO CLEAN Hot...
Motors control board for Raspberry-Pi Pico 4 DC motor 2 stepper motor 8...
MD2 drone Kit to assemble (Learning and Makers) Repairable Payload:...
Air:bit - Drone for Micro:bit Real time measures Code Bloc programmable...
Backplane prototyping board DIN case: 6 modules Level: Backplane...
Viewed products
10x Board holder + Adhesive, 4mm hole...
SUPPORT-PCB-4mm-H10-10
10x Board holder + Adhesive, 4mm hole (3.2mm min), 10mm height
In stock
Availability date:
With this product, you can secure board (PCB) having 4mm holes. The adhesive under the feet can be used to affix the board everywhere.
By removing a small part of plastic (with your cutter) you can even reduce the minimal diameter to ~3mm wich fit perfectly on board having 3.2mm holes.
This allows you to use it with Arduino board (holes of 3.2mm) or a L298 H-Bridge board (3.3mm hole).
Unfortunately, it would not be possible to use them with Raspberry-Pi because their holes are as small as 2.7mm diameter