Prototyping HAT for Raspberry-Pi

Low profile prototyping board for Raspberry-Pi

This board offers a prototyping surface for Raspberry-Pi. Like any prototyping board, it offers individual pellets to make your prototype. 

The GPIO is fully replicated on the prototyping area, which allows for on-demand connections on the prototyping board, see having a duplicate GPIO... it's sometimes useful.

The board also has fixing holes for the format HAT and pHAT! So you can use it with both a Pi and a Pi-Zero... or combine your prototype with another pHAT board placed above!

The stacking Header already included in the kit allows to consider the use of a second Hat/pHat at no additional cost! No need to stack boards? No worries, cut the pins that protrude or retrieve a female connector from another purchase. 

This kit is supplied with 11mm spacer to fix your board on a Pi / Pi-Zero or on the MicroPython NADHAT PYB405. That's enough to make a prototype with a very low profile!

Content

For each order, you'll receive:

• The prototyping board
• GPIO connector (stacking header type)
• Spacer 11mm