WiPy - MicroPython WiFi...
25 Max. per order Raspberry-Pi Pico Microcontoler RP2040 Cortex M0+ @...
The Raspberry Pi 3 - even faster than the Pi 2, 1 Giga of RAM, WiFi...
Assortment of BreadBoard wires Female-Female 300mm and 75 mm + Long...
MAX PURCHASE 1 or 2 per person during global component back-out period...
MAX PURCHASE 1 or 2 per person during global component back-out period...
Manufacturers
Desolder/Solder Gel Flux - 10 gr Smooth Flow Tack Flux NO CLEAN Hot Air...
Gravity : Measurement of pH of a solution 0 to 14 pH (+/- 0.1 pH) Gain...
Soldering Flux - Gel - 10 gr High quality, High fluidity NO CLEAN Hot...
Motors control board for Raspberry-Pi Pico 4 DC motor 2 stepper motor 8...
MD2 drone Kit to assemble (Learning and Makers) Repairable Payload:...
Air:bit - Drone for Micro:bit Real time measures Code Bloc programmable...
Backplane prototyping board DIN case: 6 modules Level: Backplane...
Viewed products
Capteur de CO2: Alim: 5V Capteur...
GRAV-SENS-CO2-MG811
Capteur de CO2:
In stock
Warning: Last items in stock!
Availability date:
*** Review ***
"Greenhouse Effect" is melting the Earth ice core every minute and creating dangerous icebergs. By knowing the exact concentration of CO2(Carbon Dioxide), we can do something to reduce the CO2 and to protect our Earth. Here is the Arduino-based CO2 sensor designed by DFRobot lovely engineer.
This is the first CO2 sensor in the Arduino market. The output voltage of the module falls as the concentration of the CO2 increases. The potentiometer onboard is designed to set the threshold of voltage. As long as the CO2 concentration is high enough (the voltage is lower than the threshold), a digital signal (ON/OFF) will be released.
It has MG-811 sensor module which is highly sensitive to CO2 and less sensitive to alcohol and CO, low humidity & temperature dependency.
Onboard heating circuit brings the best temperature for sensor to function. Internal power boosting to 6V for heating sensor best performance.
This sensor has an onboard conditioning circuit for amplifying output signal.
To ease the difficulty of using this CO2 sensor, a Gravity Interface is adapted to allow plug&play. The Arduino IO expansion shield is the best match for this CO2 senor connecting to your Arduino microcontroller.
This is an electrochemical Arduino-based CO2 sensor, it is suitable for qualitative analysis. There are other Infrared CO2 sensors, which could make a quantitative analysis.