The Raspberry Pi 3 - even faster than the Pi 2, 1 Giga of RAM, WiFi...
Assortment of BreadBoard wires Female-Female 300mm and 75 mm + Long...
Prototyping and e-learning platform for creating interactive objects or...
2 heat sinks + adhesive - high performance, for your Raspberry-Pi
Hall effect sensor - Sensitive to magnetic fields
Manufacturers
This product is a french book on Raspberry Pi 4
HAT 2x UARTs for Raspberry-Pi NXP SC161S752 Hardware UARTs FIFO 64...
Adhesive copper ribbon (single side) Width: 5mm Length: 25m
Motor 6V - Carbon Brush Reducer 25:1 4mm D Axis 20D x 41L
Motor 6V LP Reducer 9.7:1 4mm D Axis 25D x 48L
Digital oscilloscope DS1054Z (series/DS1000Z) 4 Channels at 50Mhz 4...
Viewed products
Set of 4 tweezers
X-PINCE-BRUCELLES
Set of 4 tweezers
In stock
Availability date:
Do you need to solder some SMD componants on your board or on a CMS breakout? Those clamps would be essential to finish the soldering tasks for SMD componants.
A day, we needed to solder some LEDs drivers BCR-420U-E6327 to test them. We were very happy to have the clamps under the hand to solder the componants on our SMD breakout.
We even wrote en a blog article (in French) (about the LED driver and soldering recommendation).
Content: