25 Max. per order Raspberry-Pi Pico Microcontoler RP2040 Cortex M0+ @...
The Raspberry Pi 3 - even faster than the Pi 2, 1 Giga of RAM, WiFi...
Assortment of BreadBoard wires Female-Female 300mm and 75 mm + Long...
MAX PURCHASE 1 or 2 per person during global component back-out period...
MAX PURCHASE 1 or 2 per person during global component back-out period...
Manufacturers
Desolder/Solder Gel Flux - 10 gr Smooth Flow Tack Flux NO CLEAN Hot Air...
Gravity : Measurement of pH of a solution 0 to 14 pH (+/- 0.1 pH) Gain...
Soldering Flux - Gel - 10 gr High quality, High fluidity NO CLEAN Hot...
Motors control board for Raspberry-Pi Pico 4 DC motor 2 stepper motor 8...
MD2 drone Kit to assemble (Learning and Makers) Repairable Payload:...
Air:bit - Drone for Micro:bit Real time measures Code Bloc programmable...
Backplane prototyping board DIN case: 6 modules Level: Backplane...
Viewed products
Mini gesture sensor Electric field...
DFR-3D-GESTURE
Mini gesture sensor
In stock
Warning: Last items in stock!
Availability date:
The 3D gesture sensor of DFRobot is an interactive sensor designed to capture 3D gesture recognition as well as motion tracking. This sensor can be used to detect clockwise/counterclockwise rotations or direction of a movement.
The sensor use a the GestIC® technology (from MicroChip) based on electric near field sensing technology. Detection of field in 3 dimensions associated to an advanced signal processing unit allows to detect 3D gesture with accuracy.
The effective detection range is 0-10cm. The gesture sensor can be used with your hand, finger to creates interactive projects or no touch interface (inside waterproof enclosure).
More information on the manufacturer product sheet.
Here some video about the Gesture and Proximity sensor.
DFRobot provides the enclosed product(s) under the following conditions:
This evaluation board/kit/module is intended for use for ENGINEERING DEVELOPMENT, DEMONSTRATION OR EVALUATION PURPOSES ONLY and is not considered by DFRobot to be finished end-product fit for general consumer use. Persons handling the product must have electronics training and observe good engineering practice standards. As such the goods being provided are not intended to be complete in terms of required design-, marketing-, and/or manufacturing related protective considerations, including product safety and environmental measures typically found in the products that incorporate such semiconductor components or circuit boards. This evaluation board/kit/module does not fall within the scope of the European Union directives regarding electromagnetic compatibility, FCC, CE or UL and therefore may not meet the technical requirements of these directives or other related documents.
The user assumes all responsibility and liability for proper and safe handling of the goods. Further the user indemnifies DFRobot from all claims arising from the handling or use of the goods. Due to the open construction of the product, it's the user responsibility to take any and all appropriate precautions with regard to electrostatic discharge, conducted and radiated emissions.
EXCEPT TO THE EXTENT OF THE INDEMNITY SET FORTH ABOVE NEITHER PARTY SHALL BE LIABLE TO THE OTHER FOR ANY INDIRECT SPECIAL INCIDENTAL OR CONSEQUENTIAL DAMAGES.