WiPy - MicroPython WiFi...
25 Max. per order Raspberry-Pi Pico Microcontoler RP2040 Cortex M0+ @...
The Raspberry Pi 3 - even faster than the Pi 2, 1 Giga of RAM, WiFi...
Assortment of BreadBoard wires Female-Female 300mm and 75 mm + Long...
MAX PURCHASE 1 or 2 per person during global component back-out period...
MAX PURCHASE 1 or 2 per person during global component back-out period...
Manufacturers
Gravity : Measurement of pH of a solution 0 to 14 pH (+/- 0.1 pH) Gain...
Soldering Flux - Gel - 10 gr High quality, High fluidity NO CLEAN Hot...
Motors control board for Raspberry-Pi Pico 4 DC motor 2 stepper motor 8...
MD2 drone Kit to assemble (Learning and Makers) Repairable Payload:...
Air:bit - Drone for Micro:bit Real time measures Code Bloc programmable...
Backplane prototyping board DIN case: 6 modules Level: Backplane...
Backplane prototyping board DIN case: 3 modules Level: Backplane...
MAX PURCHASE 1 or 2 per person during global component back-out period...
Viewed products
High power Mofset 40V / 10A,...
HT0740-FET-I2C-BRK
High power Mofset 40V / 10A, controllable over I2C
In stock
Warning: Last items in stock!
Availability date:
The buffy TPN2R304PL mosfet and HT0740 mosfet driver can switch a DC load of 10A @ 40V and can be driven over an I2C bus thank to the TCA9554A I2C expander. Thank to the 2 addressing bits of TCA9554A, you can control up to 4 Mosfet on a single I2C bus. The address can be configured with the cuttables traces on the back of the board.
This breakout is fully-isolated and I2C-controllable to control the Power MOSFET. The terminals are really handy to screw the load on the breakout. A status LED (white) is used as visual user feedback.
The HT0740 breakout is 3.3V or 5V compatible (as well as I2C interface). The breakout is designed to be used with straight or right angle pins.
As designed, the breakout can be plugged directly on the Raspberry Pi's GPIO (pins 1, 3, 5, 6, 9).
This breakout is also compatible with the Breakout Garden of Pimoroni where using breakouts is as easy as just popping it into one of the six slots connector.
Do not use to switch loads higher than 40V / 10A.
Despite the MOSFET part being rated for higher currents, the screw terminals are not suitable for this.
For each order, you will receive: the HT0740 Breakout, 1 male header (5 positions), 1 right angle female connector (5 positions).