Ruban GPIO pour Raspberry Pi
zoom_out_map
chevron_left chevron_right
Out-of-Stock

40 pins GPIO ribbon for Raspberry Pi

GPIO cable 2x20 pins for Raspberry Pi, OlinuXIno Micro

€5.11 (tax incl.) €4.22 (tax excl.)
Tax included
block Out-of-Stock
Secure payments
Payments are secured by LyraCollect, a French payment collection company.
Multiple delivery solutions
It is possible to delivered to your home, to a pick-up point or picked up by appointment at MCHobby
Parcels packed with care and efficiency
We prepare, pack and ship your orders with great respect and care.

A flat GPIO ribbon, efficient and practical

100% suitable for Raspberry-Pi B PLUS with 40 pins GPIO

This cable is intended for the Raspberry-Pi B+ model (not compatible with the Raspberry-Pi B, see also our downgrade cable for Raspberry Pi 2 and Pi PLUS for the 26-pin Pi-Cobbler). 

The Raspberry-Pi® 2 features a 2x20-pin connector welded to the card - these pins are GPIOs (General Purpose Input/Output) and for electronic hackers, they are the seat of a real happiness :-) 

By programming the Pi, you can put these pins in the "high" or "low" state (logic level up or down), send and receive data in I2C and SPI, and access the 3V and 5V power supply.

If you want to connect the connector (bridge) to another card, you will need this cable! It is 15 cm long and has a 40-pin connector. Pin 1 (Pin #1) is marked by the red wire.  

If you have an Adafruit case for Pi, you can even connect this cable and pass the ribbon through the opening on the side. 

For your OlinuXIno Micro

This cable also allows you to connect an OlinuxIno Cobbler to an OlinuXIno Micro card (a nano-computer that also runs on Debian Linux like the Pi but offers no less than 160 GPIOs!) 

Note: Sold without Raspberry, without Card.

RASP-RUBAN-GPIO40
3232100004733
Raspberry Compatibility
Zero / Zero W, Pi 3A, Pi 3B+, Pi 4, Pi 400, Pi 5, Zero 2 W
Interface : Connector
HAT (RPi GPIO)