4x4 Trellis Acrylic Enclosure + Hardware Kit - for Feather

Acrylic case for 4x4 NeoTrellis

NeoTrellis 4x4 is a dazzle illuminated keyboard, however it lacks a case to make it easier to use.

This product is a laser-cut acrylic (plexiglass) enclosure. Once assembled, it is ideal for transforming the NeoTrellis into a portable 4x4 device that can even be controlled by a Feather M4 Express (or other microcontrolers).
Thanks to this box, it will be possible to transform a NeoTrellis into a control interface, midi instrument or parental control... all your ideas requiring buttons and LEDs can be realized.

This product is only a case; the microcontroller, NeoTrellis board, and elastomer buttons are not included. You can easily find them on our website.

To complete this project, you will need:

• 1x NeoTrellis board/controler for 4x4 buttons
• 1x Silicon elastomer buttons (4x4 buttons)
• 1x compatible microcontroleur with I2C support (Arduino, MicroPython, CircuitPython).
• 1x (Optional but recommanded) a JST-SH4 cable (Qwiic/stemmaQt) will facilitate the wiring.

Content

For each order, you will receuve

• 1x Black Acrylic Cutout 1.5mm thick
• 10x Clear Acrylic Cutouts 3mm thick
• 4x M3 black nylon spacers 15mm long
• 8x M3 black nylon screws 8mm long
• 4x M2.5 black nylon screws 10mm long
• 4x M2.5 black nylon nuts
• 4x M2.5 standoffs 3mm long (un-threaded)
• 1x set of Little Rubber Bumper Feet (4)

These acrylic cutouts come with paper backings on both sides. You'll need to peel those off before assembly.