Ethernet Panel Mount

Panel mount Ethernet connector for your case

Here is an handy Ethernet extension cable. It will make easy to enclose a device that has an Ethernet port inside a box. This cable will work geart with Raspberry Pi, Arduino Ethernet et Beagle Bone.

The jack half has two mounting 'ears' with screws installed, 25mm apart. The ears are flexible so the holes don't have to drilled very precisely. Can be used with box walls up to 6.35mm wide. The screws can be put on from the back for 'reverse' mounting if the box thickness is a problem.

The cable between jack and RJ45 Ethernet connector makes 23cm long.

Technical details

• Panel mount Ethernet 8P socket with Ethernet 8P plug at cable end.
  Straight-through extension
• CAT 5e with 24 AWG wires
• 31 cm from tip to tip
• 23 cm cabling from jack to connector
• Two 10mm mounting screws, 24mm apart
• Plastic "boot" at Ethernet end is 20mm tall x 33mm wide
  Deep 28mm