25 Max. per order Raspberry-Pi Pico Microcontoler RP2040 Cortex M0+ @...
The Raspberry Pi 3 - even faster than the Pi 2, 1 Giga of RAM, WiFi...
Assortment of BreadBoard wires Female-Female 300mm and 75 mm + Long...
MAX PURCHASE 1 or 2 per person during global component back-out period...
MAX PURCHASE 1 or 2 per person during global component back-out period...
Manufacturers
Desolder/Solder Gel Flux - 10 gr Smooth Flow Tack Flux NO CLEAN Hot Air...
Gravity : Measurement of pH of a solution 0 to 14 pH (+/- 0.1 pH) Gain...
Soldering Flux - Gel - 10 gr High quality, High fluidity NO CLEAN Hot...
Motors control board for Raspberry-Pi Pico 4 DC motor 2 stepper motor 8...
MD2 drone Kit to assemble (Learning and Makers) Repairable Payload:...
Air:bit - Drone for Micro:bit Real time measures Code Bloc programmable...
Backplane prototyping board DIN case: 6 modules Level: Backplane...
Viewed products
PoE Splitter Micro USB Plug Isolated...
CABLE-POE-SPLITTER
PoE Splitter
In stock
Availability date:
Power over Ethernet (PoE) splitters can connect any 802.3af-capable router to any Ethernet device even if it doesn't natively support PoE!
The splitter takes a unified PoE signal (data and power) from one RJ-45 cable and separates Ethernet data from the transported power (5 VDC regulated) to make them available in two different lines. So non PoE capable device can also takes the benefits PoE networks.
This option is a economical, high-performance and fully PoE compliant device offering an Isolated 5V 2.4A from PoE network. It act as a splitter and divide power and signal with microUSB Plug on one side and Ethernet on the other side.
Basically: Connect Ethernet cable to your PoE switch / PoE hub. On this other side of Ethernet cable connect this splitter to get high quality 5V power supply (up to 2.4 A) & Ethernet.
This works great with Raspberry and many other devices powered from micro USB. It also works great with Arduino boards and compatibles that can possibly get their power from micro USB and use Ethernet network to communicates.
This device is designed to work with a true 802.af router. If you do not have any PoE Injector / PoE Hub / PoE router then you should consider the usage of a set of passive PoE cable.
As many active PoE splitters, a minimum load of 100 mA is required to make it working properly.
This should not be a problem as any Ethernet device usually requires +150mA.
For each order you will receive a 12W PoE splitter (5V output, 2.4A)