The Raspberry Pi 3 - even faster than the Pi 2, 1 Giga of RAM, WiFi...
Assortment of BreadBoard wires Female-Female 300mm and 75 mm + Long...
Prototyping and e-learning platform for creating interactive objects or...
2 heat sinks + adhesive - high performance, for your Raspberry-Pi
Hall effect sensor - Sensitive to magnetic fields
Manufacturers
IoT development kit based ESP32-Pico ESP32-Pico @ 240Mhz Flash 4Mb Ram...
HUB Module for Atom- Advanced prototyping Industrial proto board (Grove...
DIY proto module for Atom Simple proto board Case Connector 3.96 A077
ESP32 Atom development kit + MATRIX M5Atom lite ESP32-Pico-D4 @ 240 Mhz...
ESP32 ATOM development kit + BARCODE M5Atom lite ESP32-Pico @ 240 Mhz...
PYBStick interface for Adafruit's FeatherWing expansion Feather port -...
Raspberry Pi 4 4Go KIT - the ALL-IN-ONE keyboard! Power Supply HDMI...
Raspberry Pi 4 4Go KIT - the ALL-IN-ONE keyboard! Power Supply HDMI...
Prototyping board for PYBStick Prototyping Area Power terminals 3x...
Viewed products
Prototyping HAT WITHOUT EEPROM -...
HAT-PERMA-PROTO
ADA2310
Prototyping HAT WITHOUT EEPROM - PermaProto
In stock
Availability date:
Adafruit's Prototyping HAT for Raspberry-Pi
Prototyping HAT WITHOUT EEPROM - PermaProto
Recipient :
* Required fields
or Cancel
Design your own HAT for Raspberry Pi, plug in your circuits and dress up your Raspberry A+, B+ or Pi 2 with this beautiful HAT derived from the "Perma Proto" range of Adafruit.
Like the "Perma Proto", this HAT features a 2.54mm impaction (like the breadboard and prototyping plates). You can easily weld resistors, integrated circuits, LEDs, potentiometers, etc.
As on the breadboards, the holes of the card are connected in rows (via traces under the card). There are also long distribution rails for +3V, +5V and ground (GND), connected to the PI GPIO.
Near the top of the card, you will find the breakouts of almost every GPIO signal (except pin #26).
This is the basic version of Perma-Proto HAT. The circuit board (the HAT) is delivered with a GPIO 2x20 connector for Raspberry Pi (to place your Perma-Proto on the top of your Raspberry Pi). This version is not equipped with an EEPROM, so you can 'stack' them with another HAT without worrying about EEPROM address collisions.
You can customize your Perma-Proto HAT either by using the 2x20 connector provided with the card or by opting for a 2x20 pin stacking header (not included). Using a Stacking Header allows you to add another card OR plug your Cobbler over your Perma-Proto Hat.
Some welding operations are needed to place the connector on the HAT but this should not take you more than 10 minutes.
This HAT is only compatible with the Raspberry Pi A+, B+ or Pi 2! It will not be suitable for Raspberry Pi A or B models.