The Raspberry Pi 3 - even faster than the Pi 2, 1 Giga of RAM, WiFi...
Assortment of BreadBoard wires Female-Female 300mm and 75 mm + Long...
Prototyping and e-learning platform for creating interactive objects or...
2 heat sinks + adhesive - high performance, for your Raspberry-Pi
5 Max. per order Raspberry-Pi Pico Microcontoler RP2040 Cortex M0+ @ 133...
Manufacturers
Devastator Tank - Mobile robot Metal motor 45:1, 4 mm axis, 133 RPM 6V...
Maqueen Plus - Advanced educational robot Circuit charge Li-ion Line...
Maqueen PLUS with mechanic elements Fork Lift Front loader Grip holder...
Maqueen Forklift For Maqueen (>= 4.0) For Maqueen PLUS Metal servo...
Logarithmic Potentiometer 2x 10 KOhm Logarithmic - pots binded Switch...
Logarithmic Potentiometer 10 KOhm Logarithmic - pots binded Switch round...
Extension board for the Arduino Nano 2.54mm spacing connector 12V max...
DRV2605L motor controller Buzzer & vibration motors, Haptic...
Gravity : Ozone O3 sensor Range: 0-10ppm Resolution: 0.01ppm I2C...
Speech recognition, Grove Onboard microphone Very low rate 22 entries of...
Viewed products
Shield with 1 button for Wemos D1
WEMOS-D1-BUTTON
Shield with 1 button for Wemos D1
This product is no longer in stock
Warning: Last items in stock!
Availability date:
1-button shield for Wemos D1
Shield with 1 button for Wemos D1
Recipient :
* Required fields
or Cancel
This shield just contains a button wired on the D3 input. The D3 input already have a 10K ohms pull-up resistor maintaining the voltage to 3.3v. Pressing the button will ground the D3 pin.
The D3 input value will be HIGH when the button is not pressed and LOW when the button is pressed.
The button sensor shield and a section of male pinHeader to plug it on the Wemos.