25 Max. per order Raspberry-Pi Pico Microcontoler RP2040 Cortex M0+ @...
The Raspberry Pi 3 - even faster than the Pi 2, 1 Giga of RAM, WiFi...
Assortment of BreadBoard wires Female-Female 300mm and 75 mm + Long...
MAX PURCHASE 1 or 2 per person during global component back-out period...
MAX PURCHASE 1 or 2 per person during global component back-out period...
Manufacturers
Desolder/Solder Gel Flux - 10 gr Smooth Flow Tack Flux NO CLEAN Hot Air...
Gravity : Measurement of pH of a solution 0 to 14 pH (+/- 0.1 pH) Gain...
Soldering Flux - Gel - 10 gr High quality, High fluidity NO CLEAN Hot...
Motors control board for Raspberry-Pi Pico 4 DC motor 2 stepper motor 8...
MD2 drone Kit to assemble (Learning and Makers) Repairable Payload:...
Air:bit - Drone for Micro:bit Real time measures Code Bloc programmable...
Backplane prototyping board DIN case: 6 modules Level: Backplane...
Viewed products
Adafruit Pi Camera Board Case with...
RASP-MOUNT-CASE-CAM
Adafruit Pi Camera Board Case with 1/4" Tripod Mount
This product is no longer in stock
Warning: Last items in stock!
Availability date:
This is a basic, classic Adafruit Raspberry Pi Camera Board Enclosure with a black base and a clear top. The case is as minimal as it gets, coming in just two pieces of polycarbonate that snap snugly together. This case will keep your Pi Camera safe and secure while also looking super sleek. Works with Pi Camera v1 and v2.
The enclosure was designed by Mike Doell – just like our elegant, beautiful, and functional Pi Cases for Raspberry Pi Zero and Model B. Made of ultra-durable, super-glossy polycarbonate, it is both good looking and tough enough to toss into your pocket, bookbag, or toolbox. It has an easy-to-access slim opening for your camera cable to extend out from the camera module. The camera board sits nicely in the base, latching to the four little pegs, and the lid fits snugly on top. There's also a tiny hole in the lid so not to distort the capturing of images.
On the sides there are two slots so you can strap the camera to something, use zip-ties, tape, velcro straps, whatever!
On the back is a 1/4" tripod mount nut, so you can attach it to anything with a standard tripod screw. Note that to keep the enclosure compact we used a slim nut - so attach the case carefully and make sure not to push the tripod screw through the camera! Just turn it until you feel it touching the back of the camera and then unscrew a quarter turn.
This product comes with 2 case pieces. Raspberry Pi Camera Board is **not** included. No other cables or connectors or accessories are included!