MicroPython

Specials

Manufacturers

Viewed products

PYBStick to HAT (Raspberry-Pi) for Interface

PYBSTICK-HAT-FACE

Plug one or two Raspberry-Pi HATs on your PYBStick

  • 1x PYBStick interface
  • 1x Raspberry-Pi HAT interface
  • 1x optional second Pi-Hat interface

More details

In stock

6,11 € tax incl.

Description

Interfacing the PYBStick with Raspberry-Pi Hats (pHat) made easy

The HAT-FACE is the very first product of the PYBStick eco-systeme. It allows you to plug the PYBStick on a Raspberry-Pi HAT (so a "Hat interFace") and to drive the HAT from MicroPython/Arduino code running on the PYBStick.

All the basic function of the Raspberry-Pi's GPIO is mapped down to the PYBStick. So the I2C, SPI, UART buses are mapped and will help to control the HAT plugged onto the interface board.

The PinOut and schematic of the HAT-FACE will greatly helps to write your own code against the HAT you want to control.

This interface board controls the 26 first pins of the Rapsberry-Pi GPIOs (the most common) as few of the HATs does care about the extra pins (from 26 to 40). Want's to control a LCD display (SPI bus) or sensor board (I2C Bus), maybe an Adafruit Motor Shield (I2C bus)... no problem... this board is made for you.

Some MicroPython drivers for HATs are also available on the pyboard-driver github under the PYBStick section.

Content

For each order you will receive:

  • 1x Adapter board for PYBStick
  • 2x section of 13 male pin header (for PYBStick)
  • 1x section of 2x13 male pin header (for HAT)

PYBStick and Raspberry-Pi's HAT not included.

Assembling this interface board is quite easy. Just follow the instructions in the tutorial mentionned below.

Tutorials

Commentaires

30 other products in the same category: