The Raspberry Pi 3 - even faster than the Pi 2, 1 Giga of RAM, WiFi...
Assortment of BreadBoard wires Female-Female 300mm and 75 mm + Long...
75 extra flexible prototyping wires for breadboard
Prototyping and e-learning platform for creating interactive objects or...
2 heat sinks + adhesive - high performance, for your Raspberry-Pi
Hall effect sensor - Sensitive to magnetic fields
Python on microcontroler : getting started and advanced usage
Graphical Display: Sharp Memory Display 128x64 - 1.3" SPI Interface
5x transistors NPN BC547B NPN 45V Ic = 100mA hFE = 200 625mW
Athmospheric Pressure sensor using MEM's technology Pressure 50 kPa~115...
Arcade Button 100mm BLUE 1 LED (12V) Resistor included
Arcade Button 100mm GREEN 1 LED (12V) Resistor included
Arcade Button 100mm YELLOW 1 LED (12V) Resistor included
Arcade Button 100mm WHITE 1 LED (12V) Resistor included
Pin Stacking header 40 pins for: LOW PROFILE 8mm connector (housing)...
15x7 CharliePlexing LED matric 15x7 LEDs RED I2C interface For Feather
4 position display ALPHANUMERIC 14 segments + dot Yellow-Green I2C...
Music Maker for Feather Audio reader for numeric format MP3, AAC, Ogg...
Breakout of all the Micro:Bit pins...
The Klip Halo for the BBC microbit breaks out all of the pins from the microbit to pads spaced around the edge of the Klip Halo. The pads have been carefully designed and spaced so that they are ideal for for use with E-Textiles projects and also for projects that require the use of alligator clip.
The Klip Halo bolts directly onto the BBC micro:bit using five supplied screws which are secure and robust. The supplied mounting bar is used to fix the microbit to Klip Halo and already contains the required nuts as well as additional solder pads (PO, P1, P2, 3V & GND) should you require them.
There are multiple power and ground pads so that the same pads don't have to be used for every part of your project, which is a handy feature if you are using Crocodile clips. Power is supplied to the board and the microbit via the rear mounted jst connector.
When a micro:bit is connected to the Klip Halo, power can be supplied in multiple ways. These are via the USB connector on the micro:bit, the JST connector on the micro:bit or Klip Halo, or using the power rings on the Klip Halo. Depending on which option is used effects the maximum and minimum voltage that can be used and the amount of current that can be drawn from the rings on the Klip Halo. For more details and powering safety information, see the power information and safety datsheet for more information.
Supply voltage should be between 1.95V and 3.6V with 3V being the recommended voltage.
This YouTube video demonstrate the feature of the Klip Halo
For each order, you will receive the the Klip Halo. Micro:bit, alligator clip, breadboard and other items not included.